Logic Design for Array-Based Circuits
Copyright © 1996, 2001, 2002 Donnamaie E. White
Last Edit July 22, 2001
Control files vary from workstation to workstation, from simulator to simulator, from product grade to product grade, from array to array and from simulation to simulation. They are too specific to be shown here.
The outputs of the simulators are for the most part non-compact and even difficult to read. Only formatted outputs will be shown here. First, they are compact, a requirement since there are 107 I/O signals and 4 internal enable signals that the vendor requires be listed. Second, they look the same regardless of the workstation used, Dazix, Mentor or Valid. The simula-tions were run using Mentor.
All simulations shown are the result of military worst-case maximum timing. Minimum simulations are often also required.
The wafer-sort and packaged-part sort test vectors are derived from the functional simulation. (The name is vendor-specific.)
This simulation is done following vendor-specific rules. These include high-coverage, no more than 16 outputs changing in any one vector, the high limit allowed because parametric vectors and a parametric gate tree are used.
All signal transitions must be included - 0-1, 1-0 for standard macros, 0-1, 1-0, 0-Z, Z-0, 1-Z, Z-1 for 3-state macros. To prevent the vector checker from complaining, the PARAM signal from the gate tree is toggled at the end of the vector set.
There will be one error message - the initial reset will cause 64 signals to change state. This cannot be avoided. The circuit must be brought up exactly as shown, with the reset "disabled", and then the reset activated.
A vector set for a 16:1 MUX is shown in Figure 8-1. Checking of this vector set shows 100% coverage of the internal nets and primary I/O, excluding a gate tree. It passes the vector check software with the allowed exception of the reset error message.
Figure 8-1 Functional Simulation - 16:1 Mux
MINIMAL TEST SEQUENCE FOR 16:1 MUX TEST CASE ON A Q20010E ________________________________________________________________________ 1***CIRCUIT IDENTIFICATION = EESSSSDDDDDDDDDDDDDDDDYP XXEEEEAAAAAAAAAAAAAAAAOA TTLLLLTTTTTTTTTTTTTTTTUR CRCCCC0123456789111111TA LSTTTT 012345PM KT3210 T TIME 99.990 010000100101100110100101 199.990 110000100101100110100101 299.990 000000100101100110100101 399.990 100000100101100110100111 499.990 000000000101100110100111 599.990 100000000101100110100101 699.990 000000100101100110100101 799.990 100000100101100110100111 899.990 000100100101100110100111 999.990 100100100101100110100101 1099.990 000100100111100110100101o o o o o o o o
Full File Listing - Functional, Sampled Simultation 16-Bit Register with Mux Output Sample Circuit
A partial vector set for a 32-bit register similar to that in the schematics is shown in Figure 8-2. The sample step is 100 ns and the sample is taken first at 99.99 ns. The simulator output is integer - place the decimal two places from the right. The signals are listed in vendor-specified order, all inputs, all outputs, and all 3-state enables listed last. Only sampled func-tional simulations are submitted.
Figure 8-2 Functional Simulation - 32-Bit Register - Full Listing
Create a complete functional vector set for the schematics shown in the Appendix of Chapter 3.