15.1  Physical Design

Figure 15.1 shows part of the design flow, the physical design steps, for an ASIC (omitting simulation, test, and other logical design steps that have already been covered). Some of the steps in Figure 15.1 might be performed in a different order from that shown. For example, we might, depending on the size of the system, perform system partitioning before we do any design entry or synthesis. There may be some iteration between the different steps too.

FIGURE 15.1  Part of an ASIC design flow showing the system partitioning, floorplanning, placement, and routing steps. These steps may be performed in a slightly different order, iterated or omitted depending on the type and size of the system and its ASICs. As the focus shifts from logic to interconnect, floorplanning assumes an increasingly important role. Each of the steps shown in the figure must be performed and each depends on the previous step. However, the trend is toward completing these steps in a parallel fashion and iterating, rather than in a sequential manner.


We must first apply system partitioning to divide a microelectronics system into separate ASICs. In floorplanning we estimate sizes and set the initial relative locations of the various blocks in our ASIC (sometimes we also call this chip planning). At the same time we allocate space for clock and power wiring and decide on the location of the I/O and power pads. Placement defines the location of the logic cells within the flexible blocks and sets aside space for the interconnect to each logic cell. Placement for a gate-array or standard-cell design assigns each logic cell to a position in a row. For an FPGA, placement chooses which of the fixed logic resources on the chip are used for which logic cells. Floorplanning and placement are closely related and are sometimes combined in a single CAD tool. Routing makes the connections between logic cells. Routing is a hard problem by itself and is normally split into two distinct steps, called global and local routing. Global routing determines where the interconnections between the placed logic cells and blocks will be situated. Only the routes to be used by the interconnections are decided in this step, not the actual locations of the interconnections within the wiring areas. Global routing is sometimes called loose routing for this reason. Local routing joins the logic cells with interconnections. Information on which interconnection areas to use comes from the global router. Only at this stage of layout do we finally decide on the width, mask layer, and exact location of the interconnections. Local routing is also known as detailed routing.

Chapter start ] [ Previous page ] [ Next page ]

Teledyne Optech
CADalog.com - Countless CAD add-ons, plug-ins and more.

Internet Business Systems © 2016 Internet Business Systems, Inc.
595 Millich Dr., Suite 216, Campbell, CA 95008
+1 (408)-337-6870 — Contact Us, or visit our other sites:
AECCafe - Architectural Design and Engineering EDACafe - Electronic Design Automation TechJobsCafe - Technical Jobs and Resumes  MCADCafe - Mechanical Design and Engineering ShareCG - Share Computer Graphic (CG) Animation, 3D Art and 3D Models
  Privacy Policy