CHAPTER 5

Chopping: a technique for noise and offset reduction


Prev TOC Next

5.8. Conclusions

From Chapter 3 we came to the conclusion that high accuracy and large dynamic range will cost power. In the following chapter different methods to reduce 1/f noise and offset are being discussed. These methods are based on sampling and modulation and their advantages and disadvantages are reviewed. Chopping is the only method which reduces 1/f noise and offset without modifying or at least without increasing the baseband white noise. Although, chopping is a low frequency technique, there are applications where bandwidths of the signals are in the MHz range. Here, the residual offsets generated from charge injection will limit the chopping frequency.

A method to use chopper modulation at high frequencies is introduced and a low-voltage, low-power, chopped transconductance amplifier for mixed analogue digital applications has been presented. This OTA is meant for high-end applications. Chopping and dynamic element matching allow low noise and low residual offsets up to 1MHz. The sensitivity to substrate noise is tackled in the design. Experimental results show residual offsets of less than 370m V up to 1MHz chopping frequency. Second order effects like charge injection and residual offsets are discussed. By chopping, the S/N is improved with about 6dB which brings a factor 4 reduction in power.

In mixed level applications accurate voltage references are difficult to realize due to the lack of well characterized lateral pnp’s and the large offsets inherent to CMOS opamps. Another problem tackled in this chapter is related to the realization of an accurate bandgap voltage reference in CMOS. It is shown that by using chopping techniques and a chopped OTA, the accuracy of a bandgap voltage reference can be improved about ten times without laser trimming and with the benefit of reducing the 1/f noise of the amplifier. This example shows that low power is a relative term which has to be adapted to the application.

Trimble

Harris

Featured Video
Jobs
Estimator / Bidder for Rulon International at Saint Augustine, FL
Mechanical Engineer II - Requisition ID 090445 for L3 Technologies at New York, NY
ECAD Designer - Data Connectivity for Delphi at Auburn Hills, MI
Upcoming Events
17 International Multidisciplinary Scientific GeoConference SGEM 2017 at Paradise Blue Congress Center Albena Resort & SPA Bulgaria - Jun 28 - 7, 2017
LiDAR for DRONE 2017, Jun 29-30, 2017, Montpellier, France at Montpellier France - Jun 29 - 30, 2017
International Cartographic Conference 2017 at MARRIOTT WARDMAN PARK HOTEL 2660 Woodley Road NW, Washington District Of Columbia 20008 Washington - Jul 2 - 7, 2017
GI_Forum 2017 at University of Salzburg, Interfaculty Department of Geoinformatics - Z_GIS Hellbrunnerstr. 34 Salzburg Austria - Jul 4 - 7, 2017
University of Denver GIS Masters Degree Online
GeoSmartAsia
CADalog.com - Countless CAD add-ons, plug-ins and more.



Internet Business Systems © 2017 Internet Business Systems, Inc.
595 Millich Dr., Suite 216, Campbell, CA 95008
+1 (408)-337-6870 — Contact Us, or visit our other sites:
AECCafe - Architectural Design and Engineering EDACafe - Electronic Design Automation TechJobsCafe - Technical Jobs and Resumes  MCADCafe - Mechanical Design and Engineering ShareCG - Share Computer Graphic (CG) Animation, 3D Art and 3D Models
  Privacy Policy